PVL UNDERWATER CUTTING TORCH

PRODUCT DESCRIPTION

Our PVL Underwater Gas Cutting Torch is specially developed for cost-efficient and fast underwater cutting, without constantly changing parts. With the PVL Cutting Torch, the diver is able to cut 15 to 20 meters per hour. Because the PVL Cutting Torch uses Gas in combination with a specially developed cutting bracket, you can burn up to 600 meters before the cutting bracket needs to be replaced. By investing in a sustainable PVL Cutting Torch can save your company a lot of money.

The Underwater Cutting Torch uses Oxygen and Gas as a cutting medium (See table below). It has a three-hose system, which uses one hose for the Gas, one for the Oxygen and one for the cutting Oxygen. 

There are two types of Cutting Torches available:

  • Model 1 with a cutting head under 55°
  • Model 2 with a cutting head under 90°

 

Your choice of model depends on the diver’s preferences.

PVL UNDERWATER CUTTING SET

The PVL Underwater Cutting Torch kit includes:

  • 1 Underwater Gas Cutting Torch 55º or 90º
  • 1 Suitcase
  • 2 Socket wrenches
  • 1 Underwater Igniter
  • 2 Oxygen reduction valves Incl. Non-return valves
  • 1 Gas reduction vale Incl. Non-return valve
  • 1 Sets of hoses
    • 1 Gas hoses 9mm 1 x 50 meter
    • 2 Oxygen hoses 9mm 2 x 50 meter

PVL UNDERWATER CUTTING SET

The PVL Underwater Cutting Torch kit includes:

  • 1 Underwater Gas Cutting Torch 55º or 90º
  • 1 Suitcase
  • 2 Socket wrenches
  • 1 Underwater Igniter
  • 2 Oxygen reduction valves Incl. Non-return valves
  • 1 Gas reduction vale Incl. Non-return valve
  • 1 Sets of hoses
    • 1 Gas hoses 9mm 1 x 50 meter
    • 2 Oxygen hoses 9mm 2 x 50 meter
PVL International

UNDERWATER CUTTING TORCH 55°

On the right, the type 55° degree underwater cutting torch is shown. This torch is mainly used to cut sheet piles on the bottom line. In addition, this variant can also be used to cut difficult angles. 

 

Generally, the choice of model depends on the diver’s preferences.

PVL International

UNDERWATER CUTTING TORCH 90°

Shown here is PVL’s type 90° underwater cutting torch. This torch is mainly used for vertical and horizontal burn cuts. 

 

Again, the diver’s preference is the deciding factor. 

UNDERWATER CUTTING TORCH 90°

Shown here is PVL’s type 90° underwater cutting torch. This torch is mainly used for vertical and horizontal burn cuts. 

 

Again, the diver’s preference is the deciding factor. 

IGNITER

Pictured here is the underwater igniter used to light the cutting torch. The igniter is specifically designed to light the PVL cutting torch underwater. 

PVL International

PRESSURE/DIVING DEPTH TABLE

It is not possible to adjust the cutting flame underwater. You can only modify the flame by adjusting the pressure reducers above the water.

 

Pressures for the cutting Oxygen as indicated in the table apply up to 25 mm material thickness. When cutting thicker material the pressure for the cutting Oxygen can be raised without negative effects on the adjustment of the torch.

PRESSURE/DIVING DEPTH TABLE

It is not possible to adjust the cutting flame underwater. You can only modify the flame by adjusting the pressure reducers above the water.

Pressures for the cutting Oxygen as indicated in the table apply up to 25 mm material thickness. When cutting thicker material the pressure for the cutting Oxygen can be raised without negative effects on the adjustment of the torch.